April Site Wide Sale
We have detected you're not on the correct site for the car you have selected! Click the green button below to go to the correct site.
Select your car: 
BMW Mini Cooper
Mini Cooper Control Arm Nm Adjustable Pair Gen3 F56 F55

Mini Cooper Control Arm Nm Adjustable Pair Gen3 F56 F55

Mini Cooper Control Arm Nm Adjustable Pair Gen3 F56 F55

Mini Cooper Control Arm Nm Adjustable Pair Gen3 F56 F55

Mini Cooper Control Arm Nm Adjustable Pair Gen3 F56 F55
Part No: G3NMS2111-P
Internet Price $0.00
No Part Options Found based on your selected car type
or because no car type is selected.

Select your car type from the header above.
Adjustable Control Arms are a 'must have' when lowering your Mini Cooper and Cooper S. When your lower your Mini, the rear camber is greatly increased. In order to avoid accelerated tire wear ($$$), you need to correct the rear camber using Adjustable Rear Control Arms. Sold in Pairs.

Introducing the newly redesigned NM Engineering Adjustable Control Arms. While others use 1" diameter 6061 aluminum material, NM machines our control arms utilizing aerospace grade 7075-T6 1 1/4" hex aluminum bars, finished with titanium tint Type III / Mil-Spec Anodize. The use of larger material provides rigidity and strength of steel bar but without the weight.

Fits the following models:

2014-2020 F56 MINI Cooper and Cooper S Hardtop
2015-2020 F55 MINI Cooper and Cooper S Hardtop 4-Door

NM Adjustable Control Armst also features precision heavy duty rod ends made from heat treated hardened steel with self lubricating nylon race. The threaded rod ends allow user to dial the suspension camber to desired specs, crucial for the weekend track enthusiasts and professional racers. T-303 stainless steel is used for the spacers to avoid any flexing and crushing caused by suspension load.

Available with or without the optional Rubber Rod End Boot Kit.  The Rubber Rod End Boot Kit protects the rod ends against dirt and grime that may cause performance noise.  Make selection.

Finish: Titanium tint Type III / Mil-Spec Anodize


  • Kit comes with two (pair) complete bars with hardwares, set at factory arm length. Buy two kits for complete top and bottom arms replacement.
  • Vehicle with HID (Xenon) headlights can only install/replace lower control arms. (read below)
  • Heim Joint (Pillow Ball Rod End) may generate some noise for its lack of rubber bushing while still performing normally.

See NM Adjustable Control Arms installation instructions here.

Why do you need Adjustable Rear Control Arms?

The most common reasons for adding the Adjustable Rear Control Arms is to correct the rear camber after lowering the car.  Lowering the car changes the suspension geometry and induces significant amounts of negative camber.  Since the stock suspension lacks the adjustment range to correct this, the Rear Adjustable Control Arms are used.

Typically, most owners replace only the two lower control arms (one on each side).  This allows changes to the camber but it also affects toe-in simultaneously (to a small extent).  Most people accept this small toe change and carry on.

Unfortunately, the stock upper control arm is different from the lower arm and they are not interchangeable.  The Adjustable Control Arm can only be fitted to the 'lower' position.


Customer Reviews
Recently Viewed Items