The difference between an average woodwork replacement and one, which will look and last as long, if not longer, than the original, is the time spent in preparing not only the wood frames, but also the metal work it is attached to.

11 easy steps to converting your Minor to disc brakes

The front plate will have to be countersunk as shown ‘X’ to take the screws CMZ407MS, which replace the existing hexagon-headed screws, which would foul on the timing chain. When using ‘A’ plus timing covers there is a small round pressing at the bottom which needs making flat to allow timing chain clearance.

This heater is ideally suited to vehicles where light-weight and compactness are of the utmost importance without sacrificing heat output. This light-weight heater uses a powerful, space saving axial fan coupled with an efficient copper heater matrix to offer heating performance normally delivered by units twice its size! This heater is in a class of its own in terms of output for size, build quality and cost. Lead time from the UK is between 2-4 weeks.

Ensure that posts, spacers and rockers are evenly distributed along the length of the shaft to allow smooth pivoting. On no account must the valve springs be allowed to become coil-bound as this will place undue stress on the rocker and could lead to failure.

Minis built up to 1969 (i.e. MKI  &  MKII) were positive ground while MKIII and onwards were built negative ground. The polarity of the alternator can not be changed, so if the alternator you have does not conform to your car, you must change your car. 

...

This kit is an ‘add on’ for the C-AEA534 toothed belt water pump drive for the charging system. The large alternator/dynamo pulley is driven from the water pump pulley by a separate belt, thus ensuring the vehicle is still driveable should the charging system belt fail as the water pump will still function.

If your pump came to you with a warning label advising that Correct Polarity be observed, this sheet is for you.If you have converted your car to negative ground, and if you have a pump marked as above, you must also modify the pump to work properly with your electrical system.

The HIF-series carburetor differs from the HF-series primarily in: 1) The design and location of the float chamber, which has been incorporated in the body of the carburetor, and 2) The introduction of temperature-sensitive mixture control to compensate for varying fuel densities resulting from changes in fuel temperature.

Before proceeding to synchronize your carburetors and for best results, some preparation is in order. Your carburetors should be in peak condition with no play in the throttle shaft bushings. If these bushings are worn, synchronization is difficult or impossible to achieve since there will be a vacuum leak past the bushings.

Mounting instructions for the '123ignition' type : 123\MINI-R-V & 123\MINI-R-V-A+ for : all 6 & 12 Volt cars, negative earth only ! IMPORTANT Please read the entire instructions before you begin installation. If after reading you are unsure of the procedure to be followed, please ask som...

Establishing an accurate TDC reference point is of paramount importance when developing and monitoring ignition timing (and cam timing come to that). When an experienced engine builder assembles an engine - no matter whether for road or race - he will establish an accurate TDC indicator that can be used for ignition purposes.

Any deviation away from the original standard engine specification, or where a dizzy from another source is used in the engine you have, the ignition timing will generally be different from that set by the manufacturer.

Telescopic Shock Kit Fitting Instructions for the Morris Minor - The basic problems with the Minor's lever shocks are ; you have to disassemble the suspension to change them, they don't work well, and they're too expensive! Our easy, bolt-on kit enables you to add modern telescoping shocks to the front of any year Morris Minor.

CASTOR/CAMBER GAUGE INSTRUCTIONS For all intents and purposes, this gauge can be considered a finely graduated plumb line - as that is exactly what it is! Before proceeding with any measuring for each factor, make sure the vehicle is on reasonably level ground without any wheel being in.